![]() ![]() Next, I went to the AT&T router setup and page and checked for wired connections in the wired interface menu below the LAN panel. If you find out that the public IP address isn’t 192.168.1.1, then you’ll have to go back and check the AT&T router’s settings. Then, I opened my newly connected router’s configuration page, went to the IP address’ status page, and verified that the public IP address was 192.168.1.1. Next, I disconnected my computer from the AT&T router and then reconnected it. The AT&T router already has an internet connection since the internet modem is already connected to its WAN port. The chain of connection should be something like this:īe sure to note that the router is set to get an IP address dynamically from the ISP and that it’s also set to get a DNS from the Internet Service Provider Automatically.īe sure not to pinch this cable since they are pretty fragile and may lead to a shoddy connection. Now that the entire configuration was lost, I proceeded and connected the LAN ports to the AT&T router using an Ethernet cable. Configuring AT&T Fiber Router To a Third-Party Router? Step 1 Next, I proceeded to the steps that involved connecting and using my router with AT&T fiber. I then went ahead and saved these settings by clicking on the save button. However, changing my AT&T router’s IP address helped avoid conflicts that may have otherwise brought up a whole lot of weird network problems, such as jammed signals and confusion as to which data packets are supposed to go where. I had to restart my computer to force it to get a new IP address. I did this because there can’t be two asters assigning IP addresses.Ĭhanging my AT&T router’s IP address to 255.255.0.0 resigned it to a servant role whereby my router, now the primary router, was able to assign IP addresses.ĭoing this dropped my network connectivity and restarted the router. ![]() I then enabled the 172.16.0.0/255.255.0.0 range by clicking on the radio button next to it. I then clicked on the LAN tab and selected DHCP. Once the AT&T homepage opened up, I navigated to the settings menu on the homepage. One can find these default credentials on your router’s label however, if the logins are changed, they’ll be required to use the new details to access the router’s set up page. I then logged in to the router page by keying in the user ID and password. The default IP address for most AT&T routers is either 192.168.0.1. To do this, I went through these steps: Step 1įor the first step, I opened the browser on my computer and keyed in my default AT&T router’s IP address, which redirected me to the router’s setup page. How to use your own router with AT&T fiber? The process is not that complicated, as seen in the steps listed below.įirst, before connecting my AT&T fiber to my router, I had to modify my AT&T compatible router’s settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |